Square SP4200 - Manual (Page 5)

Technical Notes for the electronic radio trigger device:
The SP Flash Kit is shipped with the DRT-2G electronic to fit most popular brands.
radio flash triggering device for your convenience. The DRT-2G trigger has two channels and uses a 23A
It is an easy to use device that will give you extra battery (installed). The DRT-2G receiver uses two AAA
control in the photographic studio environment. The batteries (not included).
DRT-2G is designed to work with a variety of flash
units. We provide a wide range of sync cord adaptors
www.squareperfect.com
1.To use the DRT-2G trigger device, first
slide the trigger into the hot shoe found
on top on your camera. If a hot shoe is not
available, use the sync cord attachment
found on the side of the trigger device.
3.Switch the receiver unit ON/OFF button to
the ON position. Press the test button
located on the top of the trigger unit. You
will see a twinkling of the LED on the
receiver unit. This indicates the trigger is
working properly and is locked-in on a
working channel of the receiver.
4. Switch the remote flash unit power
switch to the ON position with the DRT-2G
receiver attached. Push the test button
on the DRT-2G trigger, it should trigger
the remote flash unit.
5.To change channels on the DRT-2G
trigger, slide the channel switch on the
side of the trigger device to the opposite
position. Next press the power switch on
the receive unit twice to reset the
receiver.
To order spare bulbs or replacement parts,
contact us at [email protected]. Also check
out our extended line of photo equipment.
2. Attach the receiver to a remote flash unit.
Use the proper sync cord adaptor
provided, plug into sync cord socket.