More setup, calibrating and integration – SV Sound SVS Subwoofer PB12-Ultra User Manual

Page 5

Advertising
background image

If you are running a pair of SV Subwoofers (Fig. 2), you will need to use
a standard “Y” cable adapter (d.) The best adaptor to use for this task has
one male RCA connection and two female RCA outputs. (Radio Shack ®
stocks them.) From the “Y” cable you can run a standard 75 Ohm RCA
to RCA signal cable (e.) to each sub, thus “splitting” the Low Frequency
Effects (LFE) and other bass signals from your receiver and effectively
feeding both subwoofers with the same signal.








C

alibration”: This isn’t only for tech minded folks, it’s critical to a

proper configuration of your home theater sound system. Fortunately,
adjusting channel balance (or, calibration) is as easy to do as it is impor-
tant. The first order of business is making sure your DD/DTS surround-
sound system is set up properly. We recommend you consult your audio/
video receiver (or processor) manual to refresh on the procedures to do
this. Generally, this requires ensuring the receiver’s test tones, or a spe-
cial test disk (like Avia) play back at the same volume from each of your
system’s full range speakers. That’s left, center, right, left surround and
right surround (and if equipped, center rear) speakers, plus the sub-
woofer . (More on sub level in a second). Skip to Page 7 (“

Powered Box

Features

”) if you aren’t familiar with your sub’s amp, and come back to

calibration.

S

ome things to check as you get ready to calibrate:

A

re your speakers set to the correct “size”? Your receiver/

processor should allow you to indicate if your speakers are “Small” or
“Large”. Selecting the size accordingly will ensure bass goes to most appro-
priate speakers, and use the subwoofer correctly too. In most instances set-

Page 5

More Setup, calibrating and integration

SV Subwoofers

DD/DTS Processor/Receiver
(Subwoofer “Out”)

Fig. 2

(e.

(d.)

NOTE: Now is a good time to select if
you want “ON” (always on) or “AUTO

ON” which turns your sub on only when a bass
signal is present.

!

“Y” cable/splitter from
receiver

Advertising
This manual is related to the following products: