SMC Networks SMCWHS-POS - Manual (Page 12)

4. Using the Printer
A. Connecting the Mini-POS Ticket Printer to the Wireless Hotspot Gateway
• Locate an optimum location for the printer. In most instances, the best
place for the printer is close to the keypad and Hotspot Gateway.
• Using the Y-type cable provided (as shown in Figure 1), connect the 7-pin
serial (PS/2) cable end to the keypad, shown as Figure 2.
Fig. 1. Y-cable Fig. 2. Connect Y-cable to keypad.
• Then, connect the 9-pin (female) cable end to the Hotspot Gateway serial
port, shown as Figure 3.
Fig. 3. Connect Y-cable to Hotspot Gateway serial port.
• Using the printer cable provided, as shown in Figure 4, connect the 25-pin
cable end of the printer cable to the printer, shown in Figure 5.
Fig. 4. Printer cable Fig. 5. Connect 25-pin cable
to the printer.
• Then, connect the 9-pin end of the cable to the Y-type cable's 9-pin (male)
connector, shown in Figure 6.
Fig. 6. Connect the printer cable to the Y-cable.
11