Servis-Rhino TURF FLEX P/N 00763618C - Manual (Page 84)

Assembly Section 3-10
ASSEMBLY
© 2004 Alamo Group Inc.
ASSEMBL
Y
Turf Flex 08/01
DRIVESHAFT ATTACHMENT
All drivelines are equipped with slide collars on end yokes. To attach to the shaft grab and pull the collar on the
end of attaching yoke toward the opposite end of the driveline. Slide the yoke (with collar depressed) onto the
shaft. Move the yoke back and forth until the collar clicks forward and locks yoke in place.
Install the Jackshaft (1) on the Front Gearbox and install Bearing (2) on the Drive End. Sandwich the Bearing
between the Bearing Supports(3) & (7). Install the Pipe Spacers (4) and retain with 1/2" x 7" bolt (5)and locknut.
Figure 15
HYDRAULIC HOSE ATTACHMENT
Remove the caps from the Hydraulic Manifold (6 Fig. 13) on the Main Frame. Hydraulic Hoses p/n 00763742 are
used for the Wing Cylinders and p/n 00762693 is used for the Rear Cylinder. Hose p/n 00765738 attaches to
the remote on the Tractor Hydraulics. On the Hose p/n 00765738 at the Tractor disconnect install Fitting p/n
02957691 (1/2 pipe thread x 1/4 J.I. C.).
3-SPOOL VALVE
Cap the two side ports of the Manifold & connect the wing Hoses to Hoses p/n 00765738 with the 1/4" male JIC
x 1/4" NPT pipe fittings.
SMV ATTACHMENT
Remove top Bolt from the Divider Gearbox Cover and attach Mounting Bracket. Bolt SMV to Bracket
1
4
5
7
3
2
FIGURE15
6
R 12-13-95