Star Trac S-UBX - Manual (Page 36)

36
620-7992 Rev 001
Adjusting Channel Menu Options
(Continued)
Manual Searching for ATV programs
If desired analog programs cannot be searched by Auto Tun-
ing, you can make use of ATV Manual Tuning to search pro-
grams manually.
1. In Channel menu, press CH+/- to select ATV Manual
Tuning item, then press VOL+ or OK to access.
2. Highlight Storage To item, press VOL+/- button to select a
channel position in which you want to store.
3. Use CH+/- to select Search item, press VOL+/- to begin
the manual ATV channel search.
Press VOL+, unit searches towards higher frequencies.
Press VOL-, unit searches towards lower frequencies.
4. The search stops when a program is found and this pro-
gram will be stored in current channel, then press OK but-
ton to save.
If you don’t press OK button to save, the found program
can’t be saved automatically and the unit will switch back
to the previously tuned channel after about 15 seconds.
Setting Audio System
Normally it is unnecessary to set audio system. However, if abnor-
mal sound occurs, you may try to adjust the audio system.
1. Navigate to ATV Manual Tuning submenu, press CH+/- to high-
light the Audio System item.
2. Press VOL+/- to select the proper audio system. Press OK but-
ton to save.
3. Press VOL+, CH+ and number button [3] at the same time to re-
turn to previous menu.