Sony RM-PP404 - Manual (Page 13)

13
Advanced Remote Operations
The numeric codes corresponding to the
component and the maker of the
component
Use the numeric codes in the tables below to control non-
Sony conponents and also Sony components that the
remote is normally unable to control. Since the remote
signal that a component accepts differs depending on the
model and year of the component, more than one numeric
code may be assigned to a component. If you fail to
program your remote using one of the codes, try using
other codes.
Notes
• The numeric codes are based on the latest information available
for each brand. There is a chance, however, that your
component will not respond to some or all of the codes.
• All of the functions on this remote may not be available when
used with your particular component.
z If programming is unsuccessful, check the following:
• If the program indicator does not light up in Step 1, the
batteries are weak. Replace both batteries.
• If you do not do Step 2 within twenty seconds after pressing
the IR SET button in Step 1, the remote automatically exits
programming mode. Start again from Step 1.
Notes
• To redo a setting during programming, press IR SET to return
to step 2.
• After Step 1, only the first function button that is pressed will
register. If you press more than one function button, it will not
register.
• In step 3, only the first three numbers entered are valid.
• If you enter an unidentified preset number, the program
indicator goes off without flashing after pressing ENTER
D.TUNING in step 4, then the remote exits programming
mode. The previously programmed settings are memorized.
Clearing all programmed signals
To clear all the programmed signals, do the following
procedure. The remote is reset to its factory-setting.
First press down MASTER VOLUME –, then AV ?/1,
and then ?/1 until the program indicator flashes three
times, then goes off.