Using the daily alarm, Trouble shooting – Sportline CARDIO 630 HEART RATE MONITOR SP1448IS01SPO User Manual

Page 10

Advertising
background image

CARDIO 630 HEART RATE MONITOR

18

19

SETTING AND USING THE DAILY ALARM
The Sportline Cardio 630 is equipped with a
Daily Alarm.

To set Alarm:

1.

In Alarm mode,

PRESS & HOLD MODE

to

enter the programming sequence.

2.

Adjust Hour by pressing

START/STOP/

RESET (S/S/R) or ADJUST (ADJ)

. Set by

PRESSING MODE

.

3.

Adjust Minutes by

PRESSING S/S/R or

ADJ

. Set by

PRESSING MODE

.

4.

PRESS & HOLD MODE

to exit the Pro-

gramming Sequence and return to
Alarm mode.

5.

Turn Alarm ON or Off by

PRESSING S/S/R

or ADJ

in Alarm mode.

NOTE: When Alarm is activated (ON), the bell icon
will appear in the lower right corner of the screen.

USING THE DAILY ALARM

Increase: S/S/R

Decrease: ADJ

Set & advance

to next setting:

PRESS MODE

POTENTIAL CAUSES FOR NO HEART RATE READING OR LONG
RESPONSE TIME:

CAUSE:

Dry Skin

SOLUTION:

Apply conductive gel thoroughly to chest area (for

Chest-Strap measurement). Tap water may help if conductive
gel is not available.

CAUSE:

Chest strap is not contacting with skin

SOLUTION:

Make sure the chest strap is fi rmly over the chest and

the Watch is securely on wrist.

CAUSE:

Dead or fl aking skin on chest.

SOLUTION:

Rub off excessive dead skin with a towel

CAUSE:

A thin layer of body grease insulates the ECG signal pre-

venting the Chest Strap or Watch from detecting ECG heart rate

SOLUTION:

Wipe chest / wrist and the back of Chest Strap/

watch with a tissue or soft towel.

CAUSE:

Hairy Skin

SOLUTION:

Apply conductive gel to chest area or wrist.

CAUSE:

Low Battery

SOLUTION:

Replace the battery in watch/transmitter and try

again.

CAUSE:

Electrical fi eld Interference from RF devices (Chest-

Strap Measurement) such as overhead power lines, etc.

SOLUTION:

Leave the area where RF source potentially exist.

CAUSE:

Issues acquiring heart rate.

SOLUTION:

Try resetting the exercise timer which will tell the

watch to begin acquiring heart rate again (see pg. 16).

SOLUTION:

Make sure watch and transmitter strap are coded

correctly (see pg. 11).

TROUBLE SHOOTING

SP1448IS01SPO.indd 18-19

SP1448IS01SPO.indd 18-19

6/10/11 12:20 PM

6/10/11 12:20 PM

Advertising
This manual is related to the following products: