Smeg FP132X - Manual (Page 27)

Instructions for the Installer
56
15.2 Positioning the oven
The appliance is designed for building-in to cabinets made from any heat-resistant material. Comply with
the dimensions shown in figures 1, 2, and 3. When installing under worktops, comply with the
dimensions shown in figure 1-3. When installing under worktops incorporating combined hobs, a gap of
at least 110 mm must be left from any side wall, as shown in figure 1. When installing in tall units, comply
with the dimensions shown in figure 1-2, bearing in mind that the top/rear of the unit must have an
opening 80-90 mm deep. Screw the 4 screws A into the inside of the frame (fig. 1). For installation under
counter-top hobs, make sure that the rear/bottom of the unit has an opening similar to that shown in
figure 1 (ref. B). See the instructions supplied with the hob for the relative positioning and fixing
procedures.
Never use the door for leverage when inserting the oven in the cabinet. Never
apply excessive pressure to the open door.