Smeg FP132X - Manual (Page 23)

Instructions for the User
52
The cleaning cycle can be programmed to start at a preset time. Turn the knob A anticlockwise to set the
Pyrolysis duration in the window B. PULL the knob A and turn it anticlockwise until the arrow C is in line
with the cooking start time required.
The cleaning cycle must always be preset.
13.6.5 How the automatic cleaning cycle works (for models with electronic analogue clock)
The table below shows an example of operation of the automatic cleaning cycle.
One minute after the start of the pyrolysis cycle, an interlock device which prevents opening of the door
is tripped and number 12 on the timer starts to flash.
The door interlock is only released later, when the temperature inside the oven drops back below 300°C,
and number 12 on the timer stops flashing.
13.6.6 Setting the cleaning cycle with electronic analogue clock
FUNCTION SELECTOR KNOB
CLEANING CYCLE DURATION
Position the function selector knob to the symbol. Hold down the symbol at the same time as
pressing the symbol .
The display will appear as shown in figure 1 with the number 1 flashing and the segments up to 6
illuminated to show the minimum duration of pyrolysis (an hour and a half). Press the
key again for 1-
2 seconds to increase the duration of this operation up to a maximum of three hours. Figure 2 shows a
period of 2 hours, 40 minutes.
6-7 seconds after the knob has been set at the symbol and the duration of pyrolysis has been adjusted, the oven
will begin the cycle and after each minute one of the segments which is lit up will go out.
The start of the pyrolysis cycle can be programmed within the next 12 hours.
After setting the pyrolysis duration, press the
key and set the pyrolysis start time by pressing the /
keys.
The internal segments will remain on and the external ones will flash until the current time is the same as
the cycle start time.