Smeg PS906 - Manual (Page 11)

32
Instructions for the installer
8.1.2 Fixing to the electric model support structure
Create an opening in the counter top with the dimensions shown in the
figure, keeping a minimum distance of 50 mm from the rear edge. The
lower part of the casing must be fully accessible after the appliance has
been installed.
This appliance can be mounted
against walls higher than the work
surface on condition that a distance
of “X” be kept between the
appliance and the wall as shown in
the figure so as to avoid damage
from overheating. Make sure that
there is a minimum of 750 mm (Fig.
1) between the hob and any shelf
that may be installed directly above
it.
This type of appliance also
requires milling to a depth of 3
mm on the counter top with the
dimensions shown in figure 2
(detail A - The right cross
section is recommended for
laminated tops where the
thickness is less than 3 mm).
Before positioning the hob, the
supplied adhesive sponge “E”
(fig. 2) must be spread out over
the entire surface of the milling.