Samsung DynaFlat TX-P3076WH - Manual (Page 11)

11
Y O U R N E W D I G I TA L T V
Rear Panel Jacks
Use the rear panel jacks to connect an A/V component that will be connected continu-
ously, such as a VCR or a DVD player.
Your TV has several input jacks, so you can connect different A/V components simulta-
neously (i.e., a VCR and a DVD, 2 VCRs, etc.).
For more information on connecting equipment, see page 14~24.
ΠDVI (Digital Visual Interface)
AUDIO INPUT jacks
Receives the digital audio signals from AV devices.
´ AUDIO-VIDEO MONITOR
OUTPUT jacks
Connect to the audio/video input jacks of a record-
ing VCR.
ˇÔ AUDIO INPUT1, 2, 3 jacks
Connect to the audio output jacks of VCRs,
DVD players and similar devices.
¨ VIDEO INPUT1, 2, 3 jacks
Connect to the video output jacks of VCRs,
DVD players and similar devices (Three sets
are available: Video1, Video2 and Video3).
ˆ DIGITAL VIDEO INPUT
(Digital Visual Interface)
jack
Receives the digital signals from a Set-top Box.
Ø S-VIDEO INPUT jack
Connect to S-VIDEO output jacks of an S-VHS VCR
or DVD player.
Note: In S-Video mode, Audio Output depends
what kind of audio input source is connected to
the side audio input jacks (AV1).
∏ UPGRADE PORT
For service only.
” OPTICAL OUTPUT jack
Connect to a Digital Audio component.
’ ANTENNA terminals
Two independent cables or antennas can be con-
nected to these terminals. Use ANT A and ANT B
terminals to receive a signal from VHF/UHF anten-
nas or your cable system.
˝ COMPONENT1, 2
(480i, 480p, 720p, 1080i)
AUDIO/VIDEO INPUT jacks
Connect to the Audio & Video outputs of DVD or
DTV Set-Top-Box.
AA68-03388A-00_eng_Chapter1 4/21/04 5:25 PM Page 11