Receiver setup (cont) 8 step4: advance operation, Step2: connecting devices, Installation (cont) – Swann ADW-300 User Manual
Page 5
Receiver Setup (cont)
8
Step4: Advance Operation
Using the Menu
You can Use
(Left / Right / Up /
Down) to select and change the settings.
By Pressing
M
(Menu), you can enter / exit OSD
menu
Audio Vol
10
Scan Time
OFF
Camera 1
ON
Camera 2
ON
Camera 3
ON
Camera 4
ON
Pair CAM
1 2 3 4
Reset
Setting Audio Volume
You can Use
(Left / Right) to
change Audio Volume from 0 to 20.
Setting Auto / Manual Scan
This function is available for multi-camera user
Scan Time will be turned off every time after you press
(Cam) for manual scan
Audio Vol
10
A. Use
(Left / Right) to change Scan
Time interval between OFF / 5 sec / 10 sec / 15sec.
B. Default setting is OFF, system will not scan and camera display
has to be manually assigned.
Skip Certain Camera(s) During Scan
Before setting Scan and Skip, make sure all cameras are paired
to assigned channels. See next pages for detail.
Scan Time
OFF
Camera 1
ON
Camera 2
ON
Camera 3
ON
Camera 4
ON
Scan Time
5 Sec
Camera 1
ON
Camera 2
ON
Camera 3
ON
Camera 4
ON
A. Simply set the skip camera(s) OFF by pressing
(Left /
Right).
Time interval between OFF / 5 sec / 10 sec / 15sec.
B. Skip Camera 2 and 4 during 5 seconds Scan time interval,
settings as shown:
1
3
TV Display as shown:
5 Seconds
5
Camera Wall Mounting
A. Secure camera stand to the wall
B. Secure camera U bracket to the
stand.
C. Adjust proper view angle then
secure the joint with T-bolt.
Camera Ceiling Mounting
A. Secure camera stand on the
ceiling
B. Secure camera U holder to the
stand.
C. Adjust proper view angle then
secure the joint with T-bolt.
Step2: Connecting Devices
Set up Camera
A. Secure the Antenna to the camera
B. Connect power cable to camera DC IN.
5V DC adapter ONLY
C. Plug on power adapter to wall outlet
D. Camera now is ready to use
Installation (cont)
Set up Receiver
A. Turn on TV and switch to AV
mode.
B. Connect AV cable Audio / Video
jack to TV AV IN. (Yellow=Video,
White=Audio)
C. Connect AV cable headset jack to
receiver AV OUT.
D. Connect power cable to receiver
DC IN.
5V DC adapter ONLY
E. Plug power adapter to wall outlet
F. Receiver now is ready to use
AV out
AV mode
AV-out
Video
Audio