Snapper 1691998 - Manual (Page 5)

installation Lawn
N O T E
Two spacers are packaged with turbo
Installation on tractor requires use of
spacer (see step 11); the not be
used.
1. Remove mower deflector and arbor cover as
follows:
a. Remove the mower deflector by removing
two carriage bolts, lockwashers and nuts.
Install this hardware on the deflector for use
when blower is removed for side discharge.
b. Remove the right hand arbor cover (A, figure
1) by removing washers and nuts in frontthat
hold cover to deck. Also, remove nuts and
washers that secure rear tabs to arbor.
2. Slip mower belt off the right hand pulley.
Remove the pulley from the arbor by removing
(D, figure 2) and washers (F). Save
washers for reinstallation. Use wood block to
blade from turning.
N O T E
Later model decks have taptite screws,
rather than 1” taptite screws, location A, figure
2. If
protrudes above arbor, new
capscrews do not need to be installed
3. Remove brake spring or spring anchor (if
equipped) and two taptite screws from arbor at
locations A, figure 2. Replace these with two
capscrews (A).
A. D.
B. Arbor Bracket E. Belt Stop, Front
C. Notch F. Washers
4. Before installing arbor bracket (B, figure 2 &A,
removewasherfrom underneath blade
brake bracket (rear capscrew). Arbor bracket is
same thickness as washer and will replace
washer. Loosen the front flange nut and remove
the rear flange nut on the blade brake bracket.
N O T E
Rear belt stop should be installed facing inside
of deck.
5. Install the arbor bracket (A, figure 3) and rear
belt stop (B) as shown. Note the different holes
for the 42” and 43” mowers. On the 42” deck,
install a at rear bracket location instead
of flange whiz nut. Tighten nut (F) snug only
belt stop will be adjusted in step 8.
Figure 1.
A. Arbor Cover
B. Nut
Figure 2.
I.
Figure 3.
A Arbor Bracket C. E.
B. Belt Stop D. Large Washers F. Jam Locknut
3