Using unix commands – Sun Microsystems Sun Fire V100 User Manual
Page 12
xii
Sun Fire V100 Server User’s Guide • December 2001
Part III Maintenance and Troubleshooting
Chapter 7 provides information about the fault and power indicators and explains
how to identify a faulty system in a rack.
Chapter 8 describes how to swap system configuration cards and how to open the
Sun Fire V100 server to add memory or a hard disk drive.
Chapter 9 describes how to reinstall the Solaris operating environment.
Chapter 10 describes the diagnostic tools that are available, and provides
troubleshooting and frequently asked questions sections.
Appendix A lists all physical and environmental specifications, and provides
information on calculating power consumption and heat dissipation.
Appendix B describes the parameters you can configure in the LOM driver
configuration file.
Using UNIX Commands
This document may not contain information about basic UNIX
®
commands and
procedures such as shutting down the system, booting the system, and configuring
devices.
See one or more of the following for this information:
■
Solaris Handbook for Sun Peripherals
■
AnswerBook2™ online documentation for the Solaris software environment
■
Other software documentation that you received with your system