User instructions – Smeg DWD63BLE User Manual
Page 20
User instructions
39
CLEANING THE FILTER UNIT
•
It is advisable to periodically inspect the centre filter C and, if necessary, to clean it. To remove
the filter, grip the tabs, turn them anticlockwise and lift upwards;
•
push the centre filter D from the underside to remove it from the micro-filter:
•
separate the two parts which make up the plastic filter by pressing the body of the filter in the
zone shown by the arrows;
•
remove the centre filter by lifting it upwards.
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE:
•
The filters should be cleaned under running water using a stiff brush.
•
It is essential to thoroughly clean the filters according to the above instructions: the
dishwasher cannot function if the filters are clogged.
•
Carefully replace the filters in their seats, to avoid damaging the wash pump.
PROLONGED DISUSE:
•
Run the soak program twice in succession.
•
Unplug the power cord from the socket.
•
Leave the door slightly open, in order to prevent the formation of unpleasant odours inside
the washing tank.
•
Fill the rinse aid dispenser.
•
Shut off the water supply tap.
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:
•
Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the
water to run from the water supply tap for a few minutes.
•
Plug the power cord back into the socket.
•
Reconnect the water intake hose and open the tap again.