Soleus Air FS1-40R-33 - Manual (Page 6)

5
OPERATING INSTRUCTIONS
Using Fan Controls
1. Set the fan on a stable, level surface.
2. Turn the fan on by pressing the POWER/SPEED button located on the control panel below the Multi-Color
display, or the POWER/SPEED button on the Remote Control.
3. Adjust the speed setting by pressing the POWER/SPEED on the control panel or remote control.
4. Pressing the MODE button on either the fan or the remote will choose the desired wind mode: Standard,
Sleep, & Natural. In standard mode the fan operates at a steady speed. In Sleep mode the fan decreases
speed in the middle of the oscillation pattern. Natural mode simulates the wind by randomly alternating the
fan speed.
5. To oscillate the fan head, press the SWING button located on the fan or the remote.
6. This fan includes a 12 hour timer. To operate the timer, press the TIMER button (located on the fan &
remote) until the desired time is visible on the Multi-Colored Display. Each button press will increase the
time by 1 hour increments. Once the timer is set the words “TIMER” and “HR” will light up on the
display.
7. To turn the fan off, press the POWER/SPEED button on the fan, or the remote control until the unit turns
off.
Using the Auto-on Feature
1. First turn the fan on by pressing the POWER/SPEED button Set the fan on the fan control panel or remote
control.
2. Once the fan is on, press the AUTO button located on the remote control. Please note, the Auto-on function
is accessible by using the remote control only.
3. “AUTO” should now be displayed on the multi-color display along with the current room temperature.
When the fan is in auto mode, it will vary speeds according to the room temperature. When the room
temperature is below 68° the fan will be in standby mode (off). When the temperature is between 68° F and
74° F the fan will operate at low speed (1). When the temperature is between 75° F and 81° F the speed
will increase to medium (2). The fan will operate at high speed (3) once the room temperature is equal to or
greater than 82° F.
Adjusting Height and Fan Head Tilt
1. To adjust the height of the fan, turn the Adjustable Height Knob (L) counter-clockwise to loosen the
stand. Adjust the fan to the desired height, then firmly tighten to secure into place.
2. To adjust the tilt on the Fan Head, loosen the knob below the Motor Housing and tilt the fan
forward/back by pulling or pushing the top of the Fan Grill. The fan will make a clicking noise while
being adjusted. Once the Fan Head is set to the desired tilt, tighten the knob to secure into place.