Servis-Rhino 4211B - Manual (Page 40)

ASSEMBLY
4211B 02/10 Assembly Section 3-6
© 2010 Alamo Group Inc.
ASSEMBL
Y
Dismounting Loader
1. Locate tractor and loader on firm level
ground.
2. Rotate parking stands from storage position
to operation position by removing linch pins
and clevis pin. Inner tube of parking stand is
now free to slide within outer tube. Reinstall
clevis pin and linch pin when parking stands
are in operation position. See Figure Asm-L-
0089.
3. Level and lower bucket to ground. Rotate
bucket down slightly to remove pressure on
hitch pins (See Figure Asm-L-0090).
4. Remove lynch pins and hitch pins from
mounting.
5. Start tractor engine and release brakes.
Retract lift cylinders, allowing parking stands
to support weight of loader. Drive tractor
forward slightly so parking stands are firmly
positioned. Operate loader control lever to
extend lift cylinders, allowing top of loader
upright to rotate forward out of upper
mounting saddle. Operate loader control lever
to retract bucket cylinder, which will curl
bucket backward causing the loader upright to
lift off of the mounting shaft. Continue to curl
bucket until loader upright has rotated upward
from the mounting position to clear front tires
or fenders on tractor.
6. Stop engine and apply brakes. Disconnect
hydraulic hoses from tractor.
7. Start tractor engine and release brakes.
Slowly back tractor out of loader.
Mounting Loader
Mounting is basically reverse of dismounting.
1. Slowly drive tractor up to loader. Shut off tractor and apply brakes.
2. Connect hydraulic hoses.
3. Start engine and release brakes. Operate loader control lever to extend bucket cylinder, which will rotate
bucket down, causing the loader upright to rotate downward placing mounting shaft in mounting pocket.
Operate loader control lever to retract lift cylinders, causing the top of loader upright to rotate rearward.
Continue to rotate loader upright into mounting saddle until upright will no longer rotate.
4. Shut off tractor, apply brakes.
5. Install hitch pins and linch pins, into mounting.
6. Remove linch pins and clevis pins from parking stands, rotate stands into storage position and secure with
clevis pins and linch pins (Figure Asm-L-0089).