Shindaiwa SP300 - Manual (Page 2)


This manual contains information for the proper assembly,
operation and care of your SP300 backpack sprayer. Carefully
read and follow the instructions contained in this manual before
operating your sprayer.
Specifications
Unpack the following
items shipped in your
sprayer box:

Wand
 Pump Lever
 Tank Assembly
and Connecting
Rod
 Small Parts Kit
 From inside the
sprayer tank,
remove the
plastic bag from
the tank strainer.
Pump Cham-
ber
Vent Dia-
phragm
Cap
Pump Lever
Tank
Nozzle
Wand
Trigger Valve
Hitch Pins and Washers
Trigger
Valve
Small Parts
Kit
Manual
Pump
Lever
Connecting
Rod
Wand
Tank
Connecting Rod
Pump Lever
Washer
Install the Pump Lever
THE SERIAL NUMBER IS LOCATED
ON THE BOTTOM OF THE TANK.
Packing Ring
Nut
Net Weight ......................................................... 8.4 pounds (3.8 kg)
Tank Capacity ......................................3.0 U.S. gallons (11.4 liters)
Tank Material ...............................................................Polyethylene
Fill Opening Diameter .................................... 4.5 inches (114 mm)
Pump Type/Material ................................................ Piston/Plastic
Operating Pressure ..........................15-65 psi (1.05-4.6 kg/sq. cm)
Wand Assembly Length................................ 27.5 inches (699 mm)
Hose Length .............................................. 69.75 inches (1771 mm)
Nozzle Installed .............................................. Red Adjustable Cone
Specifications subject to change without notice.
Introduction
Small Parts included in the plastic bag
Washer Hitch Pin
Pump Lever
Shaft
1. Remove the hitch pin from the pump lever shaft.
2. Install a flat washer on the connecting rod.
3. Lightly grease the holes in the pump lever and assemble on
to the pump lever shaft and connecting rod. Secure with flat
washers and hitch pins.
Prepare to Assemble