Sanyo PJ LINK PLC-XU106 - Manual (Page 47)

4
Note:
• The Auto Keystone function cannot work
when the Ceiling feature is set On in the
Setting Menu (p.52).
• Perfect correction of the image distortion
cannot be ensured with the Auto setup
function. If the distortion is not corrected
properly by pressing the AUTO SETUP
or AUTO SET button, adjust manually by
pressing the KEYSTONE button on the
remote control or selecting Keystone in the
Setting Menu (pp.25, 48).
• Fine sync, Total dots, Horizontal and
Vertical position of some computers
cannot be fully adjusted with the Auto PC
adjustment function. When the image is not
provided properly with this operation, manual
adjustments are required (pp.33-34).
Auto setup
Input search
This function detects the input signal automatically. When
a signal is found, the search will stop. Use the Point
▲▼
buttons to select one of the following options.
Off ......... Input search will not work.
On 1....... Input search works under the following situation.
– When pressing the AUTO SETUP button on
the top control.
– When pressing the AUTO SET button on the
remote control.
On ....... Input search works under the following situation.
– When turning on the projector by pressing the
ON/STAND-BY button on the top control or the
remote control.
– When pressing the AUTO SET button on the
remote control.
– When pressing the AUTO SETUP button on
the top control.
– When the current input signal is cut off.*
* If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when On-
Screen Menu is displayed.
Auto PC adj .
On. . . . . . . Enables Auto PC adjustment when pressing
the AUTO SET button on the remote control or
the AUTO SETUP button on the top control.
Off . . . . . . Disables Auto PC adjustment.
Auto Keystone
Auto . . . . Always works and corrects keystone distortion
according to the projector's tilt.
Manual . . . Works only when pressing the AUTO SETUP
button on the top control or the AUTO SET
button on the remote control.
Off . . . . . . Disables Auto Keystone.
Auto setup
Note:
• While Input search function is set to On 1 or On , the
status of Input and Lamp are displayed every time the
signal is switched.
• Only the last selected input source can be detected.
• If the INPUT button on the top control or the
COMPUTER 1/2 buttons, VIDEO or S-VIDEO or
COMPONENT buttons on the remote control is pressed
during Input search is in progress, Input search will stop
and go back to the previous input signal.
• Auto PC adj. and Input search and Auto Keystone
functions cannot be set Off at the same time.
• Auto Keystone function corrects vertical distortion only,
not correct horizontal distortion.
This function enables Input search, Auto Keystone correction
and Auto PC adjustment by pressing the AUTO SETUP button
on the top control or the AUTO SET button on the remote
control. Settings for those functions can be altered as follows:
Language English
Menu position
Auto setup more...
Keystone
Background Blue
Display On
Logo
Ceiling On
Rear On
Power management Off
On start Off
Closed caption CC1
Standby mode Eco
1/2
Setting