Bostitch SB-100SX - Manual (Page 6)

-6-
LOADING THE SB-100SX
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
1. Pull red pusher handle to rear until latched.
Cover will open. Pusher front will drop into
notch on top of magazine assembly.
2. Drop staple stick over magazine and slide
forward.
3. Pull back on red pusher handle; allowing
pusher assembly to rotate clockwise. Slowly
release pusher until it contacts the rear of
the staple stick.