Document Outline

• Cover
• Important information
  • Safety warnings, cautions and important information
    • Installation
    • Operation
    • Cleaning
    • Service
  • Environmental requirements
• Contents
• Chapter 1: About your interactive whiteboard system
  • SMART Board 600i5 interactive whiteboard system features
    • SMART Board 600 series interactive whiteboard
    • SMART UF75 or SMART UF75w projector
    • Extended Control Panel (ECP)
  • Included accessories
    • Remote control
    • Pens
    • Eraser
    • VGA connection kit
  • Optional accessories
• Chapter 2: Installing your interactive whiteboard system
  • Choosing a location
  • Choosing a height
  • Securing your interactive whiteboard system
    • Locking the pen tray to your interactive whiteboard
    • Securing the projector to the boom
  • Routing the cables
  • Installing SMART software
  • Changing your projector’s aspect ratio for use with your SMART Board 690 inte...
• Chapter 3: Using your interactive whiteboard system
  • Using your projector
    • Using your remote control
      • Replacing the remote control battery
      • Using the remote control buttons
      • Adjusting projector settings
    • Focusing the image
    • Adjusting the image
    • Projector connection diagram
  • Using your interactive whiteboard
  • Using the Extended Control Panel (ECP)
• Chapter 4: Integrating other devices
  • Video format compatibility
    • Native video format
    • Video format compatibility
      • SMART UF75 projector
      • SMART UF75w projector
    • HD and SD signal format compatibility
      • SMART UF75 projector
      • SMART UF75w projector
    • Video system signal compatibility
      • SMART UF75 projector
      • SMART UF75w projector
  • Connecting peripheral sources and outputs
• Chapter 5: Maintaining your interactive whiteboard system
  • Maintaining your interactive whiteboard
  • Cleaning the projector
  • Focusing and adjusting the projector image
  • Replacing the projector lamp
    • Removing and replacing the projector lamp module
    • Resetting the lamp hours
• Chapter 6: Troubleshooting your interactive whiteboard system
  • Before you start
    • Locating status lights
    • Locating serial numbers
  • Determining you interactive whiteboard system’s status
  • Resolving interactive whiteboard issues
    • Resolving operation issues
    • Resolving connection issues
    • Resolving controller module issues
  • Resolving projector issues
    • Resolving projector errors
      • Your projector stops responding
      • The “Projector Overheated”, “Fan Failure” or “Color Wheel Failure” message ap...
      • The “Lamp Failure” message appears
      • The projector Power and Service lights are off
    • Resolving image issues
      • Loss of signal
      • Partial, scrolling or incorrectly displayed image
      • Unstable or flickering image
      • Frozen image
      • Your image doesn’t fit the interactive whiteboard
      • The image from your connected laptop computer isn’t projected
      • Unaligned projected image
    • Resolving audio issues
    • Resolving network communication issues
  • Resolving ECP issues
  • Accessing the service menu
    • Retrieving your password
    • Resetting the projector
  • Transporting your interactive whiteboard system
• Appendix A: Remotely managing your system through a network interface
  • Web page management
    • Accessing web page management
    • Home
    • Control panel
    • Control panel II
      • 3D settings
      • USB Control settings
    • Network settings
    • E-mail alerts
    • Password settings
  • Simple Network Management Protocol (SNMP)
• Appendix B: Remotely managing your system through an RS-232 serial interface
  • Connecting your room control system to the SMART UF75 projector
    • Pin configuration on the projector’s RS-232 connector
    • Serial interface settings
  • Projector programming commands
    • Projector power state controls
    • Command inventory
    • Value-based command methods
      • Absolute values and adjustment values
      • Video source specification values
    • Power state controls
    • Source selection controls
    • General source controls
    • Additional VGA source controls
    • Additional Composite video source controls
    • Audio controls
    • Network controls
    • System controls
• Appendix C: Disabling user USB access
• Appendix D: Remote control code definitions
• Appendix E: Hardware environmental compliance
  • Waste Electrical and Electronic Equipment regulations (WEEE directive)
  • Restriction of Certain Hazardous Substances (RoHS directive)
  • Batteries
  • Packaging
  • China’s Electronic Information Products regulations
• Index