Speco Technologies HT-7816DNV - Manual

◈ FEATURES
1. Long IR range at night.
(50m Max. indoors, 40m Max. outdoors)
2. Adjustable level for LED activation and filter change
according to light level as follows:
Level 1 Level 2 Level 3
LED ON 8Lux 5Lux 3Lux
LED OFF 18Lux 15Lux 13Lux
Example: If selecting "Level2":
- LED turns on under 5 lux automatically
- Filter changed into B/W mode at 5 lux,
2 seconds after becoming 5 lux.
- Filter changed into color mode at 15 lux,
5 seconds after becoming 15 lux.
3. This camera uses split glass technology to prevent IR
light reflection.
4. This camera has a vari-focal IR lens to prevent focus shift
under IR lighting.
5. The IR cut filter is removed at night to receive IR light.
6. This product is weather proof to resist rain, snow and
other weather factors (IP67)
7. This product is made of a corrosion-free material to resist
rust and corrosion for extended periods of time.
8. Built-In sunshield helps give good picture quality under
various lighting conditions.
9. Day/Night mode, Mirror, Phase shift, BLC, ALC/ELC, FLK,
Color bar chart and AGC functions are controllable from
an OSD menu structure.
10. Power & video cables are concealed for extra security
(Cable through the mount).
11. Easily mount and adjust from wall and ceiling
installations.
12. Dual voltage operation. You can connect 24V AC or 12V
DC regardless of polarity. The Line-Lock function is
available when you use 24V AC
13. Adjustable IR output level to meet all conditions.
14. Built-In heater allows the camera to operate at all
temperatures.
-Heater ON/OFF temperature.
ON OFF
1 st Heater 73.5 ℉ 82.5℉
2 nd Heater 41 ℉ 50 ℉
*ON/OFF point of heater is subject to the environment.
◈ CONFIGURATION
◈ CEILING MOUNT INSTALLATION #1
1. Make a hole Ø 30mm in diameter for routing cable.
2. Using the mounting plate, drill four holes on the ceiling.
3. Insert the anchors.
4. Attach the screws.
◈ CEILING MOUNT INSTALLATION #2
1. Adjust horizontal angle.
1) Loosen the bolt to adjust the horizontal angle of the
camera.
2) Use the WRENCH to tighten the bolt after adjusting the
camera.
2. Adjust vertical angle
1) Loosen the bolt to adjust the vertical angle of the
camera.
2) Use the WRENCH to tighten a bolt after adjusting the
camera.
◈ WALL MOUNT INSTALLATION #1
1. Make a hole Ø30mm in diameter for routing cable.
2. Using the mounting plate, drill four holes on the wall.
3. Insert the anchors.
4. Attach the screws.
◈ WALL MOUNT INSTALLATION #2
1. Adjust horizontal angle.
1) Loosen the bolt to adjust the horizontal angle of the
camera.
2) Use the WRENCH to tighten the bolt after adjusting the
camera.
2. Adjust vertical angle
1) Loosen a bolt to adjust vertical angle of the camera
2) Use the WRENCH to tighten a bolt after adjusting the
camera.