Connecting your monitor, Switching on your monitor – Sunbeam FP7820 User Manual
Page 8
6
Connecting your Monitor
Be sure to read the 'Safety'
Information located in the
Monitor Safety and Warranty
Information Manual before
carrying out this procedure.
1.
Turn off your computer and all attached devices.
2.
Connect the signal cable to the video port on the back of your computer.
This port might be directly attached to your computer (figure A), or it
might be part of a video adapter card (figure B). The video port on your
computer or video adapter card might be blue to match the blue
connector on your monitor’s video cable.
3.
Connect the power cord to the monitor first, then insert the plug into a
properly grounded electrical outlet.
Switching on your Monitor
1.
Switch on the power source and your computer.
2.
Switch on your monitor by pushing and releasing the power switch
marked .
To switch off your monitor, push and release the power switch again.
3.
Turn on the monitor and then the computer.
4.
To update or install device drivers, follow the instructions in the Device
Driver Installation section on page 7.
5.
To optimise the displayed image, run Auto Setup by following the
instructions in the Auto Setup section on page 10.
T710_E_update.fm Page 6 Tuesday, July 9, 2002 4:06 PM