Sunbeam HS7900 - Manual (Page 4)

1. Insert the plug into the power outlet and
turn the power on.
2. Move the on/off switch to the on position (I).
3. Select the desired heat level by rotating the
temperature dial on the side of the styler. Use
lower heat for fine hair, or for smoothing
almost-straight hair. Use higher heat for
thicker hair, or more resistant curls.
4. Allow the straightener to heat for several
minutes before using.
5. Brush your hair thoroughly. Separate out a
section of hair approximately 4cm in width
and smooth it with a comb.
6. For best results, start at the scalp and work to
the ends of the hair. Place the separated
section of hair between the flat plates and
close the handle gently around the hair.
7. Hold the styler in position for 3 to 5 seconds,
depending on the type of hair (3 seconds for
fine hair and up to 5 seconds for thicker hair).
8. Once the hair is heated carefully slide the
styler along the section of separated hair,
making sure that the hair is heated and
straightened all the way to the ends.
9. Select another section of hair and repeat the
process. Continue until all of the hair has
been straightened.
Using your Straightener.
Care and Cleaning.
After use, remove the plug from the power
outlet and allow the styler to cool before storing.
To clean the plates, wipe with a soft cloth
moistened with a solution consisting of a small
amount of hair shampoo in warm water. Wipe
the outside of the styler with a damp cloth, and
dry with a soft cloth.
Do not wrap the cord around the styler when
not in use. Store in a dry place.
Sunbeam is a registered trademark. Made in China. Due to
minor changes in design or otherwise, the product may
differ from the one shown in this leaflet. Approved by the
appropriate Electrical Regulatory Authorities. Backed by
Sunbeam‘s 2 Year Replacement Guarantee and National
Service Network. © Copyright. SUNBEAM CORPORATION LIMITED 2002.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
For more information or advice on this or any other
Sunbeam appliance, visit www.sunbeam.com.au
or contact the Sunbeam Consumer Service Line.
Australia 1800 025 059
New Zealand (09) 912 0747.