Saleen 10-8002-C12167A - Manual (Page 5)

Figure 1
Figure 2
Order of Operations:
1. Using paint thinner, spray surfaces of
quarter window frame that will be
bonded to the rear quarter panel
window, and wipe those surfaces
until they are clean and dry. Also
clean the quarter window with glass
cleaner. Wipe both surfaces dry.
(Figures 1 & 2)
2. Apply urethane primer (see p. 4) to
the outer edge of the window (Figure
2) and the quarter window frame.
3. Tape off the entire outline of the window
(beginning of tape-off shown in Figure
3). The tape should go all the way up to
the groove around the window, but not
into the groove. (This is to make sure
the urethane does not get on the car)
4. With the narrow tip on the pneumatic
gun (see p. 4), apply urethane (see p. 4)
to the groove on the bond-surface of the
quarter panel window (Figure 4).
Figure 3 Figure 4
5