Source Technologies STM.58B - Manual (Page 6)

8 9
Connect the car cigar JACK charger into the printer or battery holder.
3-6 Usage of Cigar Jack for charging
Printer
Battery holder
NOTE
Use the Cigar Jack offered by the manufacturer .
Optional
Input 12 ~ 24V
8.4V 0.8 ~ 1.2A Output
3-5-1 The status of lamp in charging
Status charging charging complete
Charging Lamp Red Green
NOTE
In the case the battery is not fixed properly in the holder, the red lamp will be
blinking, Then, extract and reinsert the battery.
3-5 Battery charger usage
DC Jack
1. Insert the battery into the battery holder as shown above
2. Connect the DC JACK to the power electrical outlet.
3. Plug the power code into the electrical outlet.
4. Once the charging is completed, remove the battery from the holder.
Optional
Lamp