Sony D-V55 - Manual (Page 25)

26 GB
Connecting to other
stereo equipment
You can play back a CD through other
stereo equipment or record a CD on a
cassette tape or video tape. Refer to the
instruction manual supplied with other
equipment for details.
Before making connections, turn off
each equipment.
Notes
•Before you play the CD, turn down the
volume of the connected equipment so as
not to damage the connected speakers.
•The beep sound is not output from the
AUDIO/VIDEO OUT jack.
•You cannot adjust the volume of output
signals from the AUDIO/VIDEO OUT
jack on this player.
•When you record a CD on a cassette tape
using a tape recorder that has the blank
search function, release the ESP function.
If the ESP function is on, the blank search
function does not work.
Stereo system ,
cassette recorder,
radio cassette
recorder, etc.
To LINE IN or
REC IN
Red
To AUDIO/
VIDEO OUT
AV monitor cord
(supplied)
To resume playing from the
point you stopped the audio CD
(Resume function)
Normally, every time you stop and
play, playing starts from the beginning
of the audio CD. The resume play
function, however, let you listen to from
the point where you last turned off the
player.
Set RESUME to ON.
To cancel resume play, set RESUME to
OFF.
Notes
•Even if RESUME is set to ON, playing
starts from the beginning when you open
the lid.
•The resume point may be inaccurate by
about 30 seconds.
To turn off the beep
You can turn off the beep that sounds as
you operate your player.
Disconnect the power source (AC
power adaptor or alkaline batteries).
While you press and hold down
p,
connect the power source again. To
make the beep sound again, disconnect
the power source, and then connect it
without pressing
p.
Note
•While playing the VIDEO CD, the beep
does not sound.
White
RESUME
ON OFF