Samsung 220TN - Manual (Page 84)

Internet in the
Client screen. that indicates that the LAN connection is disconnected. In this case, connect
using another LAN cable.
2) Check if the settings of the 'Network' tab of 'Settings' have been properly set
up. The default setting is "DHCP". If your network uses a static IP address,
select 'Use the following IP address' and then enter the appropriate IP address
information.
The contents
(video, voice) on
the server do not
play smoothly on
the Client Monitor. This is because the data is transmitted over the LAN. Check your LAN
connection status.
I have connected a
digital device such
as a digital camera,
camcorder or USB
memory to the USB
port, but they do
not work. This model supports USB devices that support removable disk functions without
an additional driver installation. Check if the device you want to connect to is a
device that supports the removable disk function without an additional driver
installation.
The file list does
not appear. 1) Check the files on the card. If only abnormal files (e.g. 0KByte, broken JPEG)
exist, the files do not appear on the screen.
2) The time required to display is determined by the size of the file. Wait a
moment.
3) Check if the format of the file is supported by the Client Monitor. If the
extension of the file has been changed, the file will not be played.
Check if the power cord and the video cables are properly connected to the computer.
Check if the computer beeps more than 3 times when booting.
(If it does, request an after-service for the main board of the computer.)
If you installed a new video card or assembled the PC, please check if the adapter(video) driver and
the monitor driver are properly installed.
Check if the scanning ratio of the video screen is set at 56 Hz ~ 75 Hz.
(Do not exceed 60 Hz when using the maximum resolution.)
If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode, remove
the Display Adapter at the "Control Panel → System → Device Administrator" and then reboot the
computer to reinstall the adapter (video) driver.
If problems repeatedly occur, contact an authorized service center .
Q & A
Question Answer
How can I change the frequency? Frequency can be changed by reconfiguring the
video card.
Note that video card support can vary, depending on
the version of the driver used.
(Refer to the computer or the video card manual for
details.)
How can I adjust the resolution? Windows XP :
Set the resolution at the Control Panel →
Appearance and Themes → Display → Settings.
Windows ME/2000 :
Set the resolution at the Control Panel → Display →
Settings.
Contact the video card manufacturer for details.