Schumacher INSTANT POWER Jump Starter and DC Power Source IP-125 User Manual

Page 11

Advertising
background image

7

If the 12v dC device draws more than 15A or has a short circuit, the

4.

internal circuit breaker of the Instant Power™ will trip and disconnect the

power to the device. disconnect the 12v dC device. The breaker will

automatically reset after an overload occurs.

The dC power outlet is wired directly to the internal battery. Extended

operation of a 12v dC device may result in excessive battery drain. Recharge

immediately after unplugging the 12v dC device.

Appliance Type

Estimated Wattage

Estimated Usage Time

Cell Phone

4 watts

36 hours

Fluorescent Light

4 watts

36 hours

Radios, Fan

9 watts

16 hours

depth Finder

9 watts

16 hours

Camcorder, vCR

15 watts

9.6 hours

Electrical Tool

24 watts

6 hours

Electrical Cooler

48 watts

3 hours

Car vacuum, Air Compressor

80 watts

1.8 hours

NOTE: Estimated run-times. Actual time may vary. Times are based on the

internal battery being fully charged

MAINTENANCE INSTRUCTIONS

9.

After use and before performing maintenance, unplug and disconnect the

9.1

Instant Power™ (see sections 3 and 4).
Use a dry cloth to wipe all battery corrosion and other dirt or oil from the

9.2

battery clips, cords, and the Instant Power™ case.
Ensure that all of the Instant Power™ components are in place and in good

9.3

working condition, for example, the plastic boots on the battery clips.
Servicing does not require opening the unit, as there are no user-serviceable

9.4

parts.
All other servicing should be performed by qualified service personal.

9.5

MOVING AND STORAGE INSTRUCTIONS

10.

Store the Instant Power™ in an upright position.

10.1

Store inside, in a cool, dry place.

10.2

do not store the clips on the handle, clipped together, on or around metal,

10.3

or clipped to cables. The clips on the Instant Power™ are live and will

produce arcing or sparking if they come in contact with each other. To prevent

accidental arcing, always keep the clips on the storage holders when not using

it to jump start a vehicle.
If the Instant Power™ is moved around the shop or transported to another

10.4

location, take care to avoid/prevent damage to the cords, clips and Instant

Power™. Failure to do so could result in personal injury or property damage.

do not use and/or store the Instant Power™ in or on any

area or surface where damage could occur if the internal battery should

unexpectedly leak acid.

Advertising