Sony RM-VL610 - Manual (Page 30)

30
Example: To program the
procedure above to the SYSTEM
CONTROL 2 button
1
Press and while holding
SET, press the SYSTEM
CONTROL 2 button.
The SET indicator light turns
on.
If a System Control function
(System Control Macro) has
already been set on the button,
the SET indicator flashes twice.
The setting procedure is
automatically canceled.
2
Set the System Control
function.
With this example, press
buttons in sequence as below:
You can program up to 16
consecutive steps on each of
the SYSTEM CONTROL
buttons (1 – 4), including the
initial step of pressing switch
to a Component Select button.
3
Press SET to complete the
programming.
The SYSTEM CONTROL
button light turns off.
To program a new series of
operations for those buttons
which already have a control
program set
Erase the program (page 31).
Notes
• If you interrupt the procedure at any
point for over 20 seconds, the setting
mode ends and the series of
commands will be programmed up to
that point. In this case, clear the
program (page 31) and start again
from Step 1 to set the entire program
from the beginning. You cannot
continue programming once the
setting mode ends.
• If a SYSTEM CONTROL button has
already “learned” a remote control
signal (page 16), you can program a
System Control function (System
Control Macro), but the function does
will not work until you clear the
Leaning function. To clear the
Learning function, see “Changing or
erasing the function of a “learned”
button” on page 22.
• If you change the component code
number (page 10) or program a new
signal by using the Learning function
(page 16) on a key or a button that
has been programmed with a series
of commands using the System
Control function, the new signal will
be transmitted when you press the
corresponding SYSTEM CONTROL
button.
• While in setting mode, you cannot
clear any operation step you have
programmed. If you have
programmed an incorrect operation
by mistake, start again from Step 1.
• If you try to program more than 16
steps, the System Control setting
mode ends, and the 16 steps you have
programmed are registered. If you
want to program the steps again,
clear the program (page 31) and start
again from Step 1.