Sony D-EJ758CK - Manual (Page 17)

17
Installing in a car
Replacing the fuse of
the car battery cord
If the CD player does not operate, check the
fuse. If it is blown, replace it as follows:
1
Turn off the CD player and remove
the cigarette lighter plug from the
cigarette lighter socket.
2
Remove the plug end by turning it
counterclockwise.
3
Remove the defective fuse from
the plug.
4
Insert a new fuse into the plug.
5
Replace the plug end by turning it
clockwise.
Notes
• Be sure to use a fuse of the same amperage and
length as the one to be replaced. Never use a
piece of wire as a substitute for the fuse.
• If the fuse is blown again after replacing it,
contact your nearest Sony dealer. In such a case,
bring the defective fuse to the dealer with you.
Notes on the car connecting pack
• If no sound is heard or the car connecting pack is
ejected, change the direction of playback on the
car cassette deck.
• Never insert the cord end of the car connecting
pack into the cassette insertion door. Otherwise,
the cord may break or the car cassette deck may
be damaged.
• You cannot use the car connecting pack with
some car cassette deck.
• The cord should be placed so that it does not
hinder driving.
• To disconnect the cord from the CD player, pull it
out by grasping the plug. Never pull the plug out
by the cord.
• With some car cassette decks, you may hear some
rattling noise from the car connecting pack.
However, this is not a sign of malfunction.
Remove
Plug end
Fuse
Cigarette lighter plug