Star Trac E SERIES BIKES E- UB 8100 - Manual (Page 11)

SSTAR TRAC E SERIES BIKES OWNER’S MANUAL 11
Next, position the display weldment on the top of the neck tube and secure with
the four M6 x 65 allen head bolts and four star washers. Take care to route the
display cables through the opening in the display weldment. All cables should
exit out the top of the neck tube as shown in the image below. Tighten the four
bolts to a torque of 8-10 lbs-ft.
3. Install the Seat Post
While pulling the release knob out, slide the seat post into the frame until the
threaded hole in the seat post is accessible through the external hole in the frame.
Install the M6 x 10 bolt through the opening in the frame and into the back of the
seat post and tighten to a torque of 8-10 lbs-ft.
Secure the seat post sleeve to the frame with two M4 x 20 allen head bolts.
Check the seat post for proper operation by pulling on the seat post release knob and
verifying that the seat post will slide up and down the full travel without difficulty.
NOTE: THIS COMPLETES THE ASSEMBLY OF THE BASE FRAME, TO COMPLETE
ASSEMBLY OF LED DISPLAY CONTINUE TO PAGE 15
Step 3a
Step 2b
Step 3b