SIIG 04-0676A - Manual (Page 4)

1
2
3
4
5
6
7
4
5
Attach the bubble level (G2) to the wall plate, with the help of an assistant place the wall plate into position
against the wall, using the bubble level to keep it level.
Mark four holes to be used for securing the mount and place the wall plate aside.
NOTE: The concrete anchors must be used for concrete installation.
Place your TV screen down on a soft, flat surface, and locate the
threaded mounting points that are located on the back of the
display.
B) Concrete/Brick Installation
Drill holes using an electric drill and 5/16" masonry bit to a depth of approximately 2".
Insert a concrete anchor (F) into to each hole. If necessary, a hammer can be used to lightly tap each anchor into
Once all of the anchors are in place, move the wall plate back into position. Check the bubble level to verify that
the wall plate is level.
3
According to the size of the mounting point, choose the
corresponding screw and hole on rectangle washer (D), then
thread them in line as shown.
Step 2 Display Bracket Installation
To ensure optimal installation, this kit includes various screws of
different diameters and lengths. 1
2
Determine which screw (A1/A2/B1/B2/C1/C2) is the correct length
by carefully inserting a straw, or toothpick, and mark how deep
the mounting point is.
Tighten each bolt with a 7/16" socket or open ended wrench by turning clockwise until tight.
Insert bolt (E) and washer (G1) into each concrete anchor in the wall. Do not tighten until all bolts are in place.
If your display has a curved back or a recessed thread mounting
point, place the spacer (H) between the mounting bracket and
display and then choose screw (A2/B2/C2) to match.
4