Sony XR-CA630X - Manual (Page 13)

13
For stations without alternative
frequencies
Press either side of (SEEK) while the
station name is flashing (within
8 seconds).
The unit starts searching for another
frequency with the same PI (Programme
Identification) data (“PI SEEK” appears).
If the unit cannot find the same PI, the unit
returns to the previously selected frequency.
Staying with one regional programme
When the AF function is on: this unit’s factory
setting restricts reception to a specific region, so
you won’t be switched to another regional station
with a stronger frequency.
If you leave this regional programme’s reception
area and would like to take advantage of the
whole AF function, select “REG-OFF” from the
MENU (page 18).
Note
This function does not work in the United Kingdom
and in some other areas.
Local Link function
(United Kingdom only)
This function enables you to select other local
stations in the area, even if they are not stored on
your number buttons.
1
Press a number button ( (1) to (6) ) on
the card remote commander that has a
local station stored on it.
2
Within 5 seconds, press the number
button of the local station again.
3
Repeat this procedure until the
desired local station is received.
Receiving traffic
announcements
— TA/TP
By activating the Traffic Announcement (TA)
and Traffic Programme (TP), you can
automatically receive FM station broadcast
traffic announcements as they occur. These
settings function regardless of the current FM
programme/source, CD/MD; the unit switches
back to the original source when the bulletin is
over.
Press (TA) repeatedly until “TA-ON”
appears.
The unit starts searching for traffic
information stations.
“TP” indicates reception of such stations, and
“TA” flashes during an actual traffic
announcement. The unit will continue
searching for stations available with TP if
“NO TP” is indicated.
To cancel all traffic announcements, select “TA-
OFF.”
Tip
You can also cancel a current announcement by
pressing
(SOURCE) or (MODE) .
Presetting the volume level of traffic
announcements
You can preset the volume level of the traffic
announcements so you won’t miss hearing them.
1
Turn the volume control dial to adjust
the desired volume level.
2
Press (TA) for 2 seconds.
“TA” appears and the setting is stored.
Receiving emergency announcements
If either AF or TA is on, the unit will switch to
emergency announcements, if one comes in
while listening to an FM station, a tape or
optional CD/MD.
To Press
Cancel current
announcement (TA)