Sunrise Medical Quickie Match Point - Manual (Page 17)

930469 Rev. A
X . S e t - u p & A d j u s t m e n t 33
H. FOOTREST
NOTE– Use a torque setting of 100 in./lbs. when
adjusting footplate.
1. Height Adjustment
a. Remove footrest bolt and slide footrest up or
down inside tube to correct position.
b. Tighten bolt securely.
2. Horizontal Adjustment
a. Loosen set screws at footrest receivers.
b. Slide footplate assembly to desired position.
c. Retighten screws.
3. Footplate Angle Adjustment
a. Loosen flathead screws.
b. Reposition footplate to desired angle and
retighten screws.
I. INTEGRAL 5TH WHEEL
The Match Point comes standard with the 5th
wheel. This increases rear stability.
Caster Height Adjustment for the Single Integral
5th wheel.
The anti-tip height can be adjusted by repositioning
the spacers within the rear caster journal.
Each caster journal is equipped with four 1/8" thick
spacers (1).
a. To lower the casters remove desired spacers and
position them on the bottom of caster journal (2).
b. To raise the height of the caster remove desired
spacers and move to the top of the caster journal.
X . S e t - u p & A d j u s t m e n t
930469 Rev. A
32
4. Toe-in and Toe-out
Toe-in and Toe-out are terms that relate to how well
the rear wheels of the chair are aligned. This will
affect how well the chair will roll. Drag or resistance
occurs in a wheelchair when the rear wheels are not
properly aligned.
Toe-in or toe-out can be slightly adjusted by adjusting
the eccentric axle sleeve.
5. Eccentric Axle Sleeve Adjustment
2° eccentric axle sleeves are standard on chair and are
used for toe-in toe-out adjustments. Refer to “Axle
Sleeve Adjustments” for tightening procedures.
a. To add 2° of camber:
1. Loosen axle sleeves.
2. Position axle sleeves with large lobes down (A).
b. To subtract 2° of camber.
1. Loosen axle sleeves.
2. Position axle sleeves with large lobes up (B).
c. Make sure both sleeves are aligned equally.
G. CASTER FORKS
1. Caster Wheel Replacement
a. Loosen the bolt and remove the caster wheel and
the two washers.
b. Position new caster wheel into fork.
c. Carefully position washer on each side of
caster wheel.
d. Insert bolt. Tighten securely.
A
B
Single Integral 5th Wheel
Front of chair Rear of chair