Speco Technologies DNR Bullet Day/Night Weather-proof Camera VL7038IRVF - Manual (Page 26)

25
1) When the SPECIAL menu screen is displayed, press the Function
Setup switch so that the arrow indicates 'PRIVACY'.
2) Set up the mode using the Function Setup switch.
- AREA : You can select up to 12 PRIVACY areas.
- MODE : Determines whether to use the area selected in the AREA.
- MASK COLOR : Determine area color. You can select Green, Red, Blue, Black, White, Gray.
- MASK TONE : Adjust the brightness of MASK COLOR.
- TOP/BOTTOM/LEFT/RIGHT :Adjust the size and position of the selected area.
- RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL menu.
◆ DIS (Digital Image Stabilizer) :
This function mitigates any picture movement due to external factors such as wind.
◆ COMM ADJ (Communication Adjustment) :
This function sets up the camera communication status when controlling the camera through
an external control device.
1) When the SPECIAL menu screen is displayed, press the Function Setup switch so that the
arrow indicates 'COMM ADJ'.
2) Set up the mode using the Function Setup witch.
- CAM ID : Determines the camera's identification number (between 0 and 255).
- BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- RET PKT : Determines whether to send a command back to the controller device when a
communication control command is sent to the camera.
- DISP ID : Display camera title on top left corner of the screen.
- PROTOCOL : You can select one of various protocols. STW(SPD), PELCO-P, PELCO-D,
VICON, PANASONIC, BOSCH, HONEYWELL, SEC.
* Initial value of communication adjustment
☞ NOTE
■ As the DIS function uses the digital zoom the camera's resolution will decrease.
■ DIS doesn’t operate when background illumination is too low.
■ DIS doesn’t operate when object pattern is monotonic as like sky or white wall.
Item
Initial value
Camera ID
1
BAUD RATE
9600
UART MODE
8-NONE-1
PET PKT
ENABLE