Sony XDCU-50 - Manual (Page 12)

12
Names and Functions of Parts
i LINK indicator
Lights in green when a data transfer link between this unit
and a camera adaptor has been established, and when
device authentication between the camera adaptor and the
camcorder has been established.
System setting switches
Use the supplied front cover to protect the system setting
switches from misoperation.
Check the setting of the individual switches and change the
switch setting as required, then attach the front cover to the front panel of the unit with the supplied front cover
attachment screws.
SYSTEM SETUP switches
Set up the system format of this unit (number of system
lines/frame rate) to match the system format of the
camcorder.
For details, see “Setting the System Format” (page 19).
OUTPUT SELECT switches
Make settings related to the output signals of this unit.
DOWN CONVERTER ADJUSTMENT switches
Specify the methods used to adjust down converted
signals. These adjustments are applied to SDSDI signals
output from the OUTPUT SDI connectors and to SD
analog composite signals output from the VIDEO
OUTPUT and REMOTE connectors.
The settings of these switches do not affect the signals
output from the OUTPUT SDI connectors when those
signals are HDSDI signals.
Front cover
Front cover attachment screws
Switch name Settings Description
1080i/720p 1080i: Interlace mode, 1080
lines
720p: Progressive mode, 720
lines
Sets the number of system lines.
59.94/50 59.94: 59.94 Hz (NTSC area)
50: 50 Hz (PAL area) Sets the system frequency.
Switch name Settings Description
HD/SD HD: HDSDI signals
SD: SDSDI signals Selects the type of signals output from the
OUTPUT SDI connectors of this unit.
WIDE ID ON: Add a wide ID signal when
the aspect ratio is 16:9, and
do not add a wide ID signal
when the aspect ratio is 4:3
OFF: Never add a wide ID signal
Specifies whether to add a wide ID signal
to composite signals output from the
VIDEO OUTPUT and REMOTE
connectors, and to SDSDI signals output
from the OUTPUT SDI connectors.
SETUP (NTSC
area only) ON: Add setup
OFF: Do not add setup When you are using the unit in an NTSC
area, specifies whether to add a 7.5%
setup to the composite signals output from
the VIDEO OUTPUT and REMOTE
connectors.
Note