Sundance Spas 7'7-inch x 7'7-inch and Smaller - Manual (Page 10)

9 Sundance Spas Gazebos Installation Instructions WillowWood
Step 16
Attach the Tie Plate Assembly to the
Wall Assembly
NOTE: You will need an assistant for
this step.
Lift the completed tie plate assembly, and
place it on top of the wall unit assembly, as
shown in diagram 16. The tie plate
assembly will overhang the wall assembly
approximately 1/8". With this in mind,
attach one corner of the tie plate assembly
to the wall assembly using two 2-1/2"
screws, allowing for the 1/8" overhang. Do
not try to align or square anything at this
time. That will be done in The next step.
Step 17
Align the tie plate assembly with the
wall assembly.
Move to the opposite corner from the one
you just secured. Push or pull on the
corner of the wall assembly as needed to
align the corner with the tie plate assembly.
Try to achieve 1/8" overhang. When the
corner is aligned, secure it with two 2-1/2"
screws as shown in Diagram 17. Move to
the next corner and repeat the procedure
until all four corners are secured.
Align this
corner first
Align this
corner second
Diagram 16
Diagram 17