Sharp MODEL R-2197 - Manual (Page 4)

3
A30019, SCA R2197 O/M
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity, and the feature sticker from the outside of the door, if
there is one. Remove the protective film (blue film) from the outer case cabinet. Check the unit for any
damage, such as a misaligned door, damaged door seals around the door or dents inside the oven cavity
or on the door. If there is any damage, please do not operate the oven until it has been checked by a SERVICE
CENTRE APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1) Operation manual and cooking guide
2) Caution sheet (SPECIAL INSTRUCTIONS AND WARNINGS: part code TCAUHA276WRRZ)
3. The oven should not be installed in any area where excessive heat and steam are generated, for example, next
to a conventional oven unit.
The oven should be installed so as not to block ventilation openings.
Allow at least 40 cm on the top and 5 cm on the both sides of the oven for free air space. And the rear of the oven
should touch the wall.
4. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal injury
for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230-240V, 50Hz.
5. It is recommended that a separate circuit serving only this appliance be provided.
6. This appliance must be earthed.
7. Operate the oven from a general purpose outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
8. The unit may be secured to a countertop or stand. There is a screw hole in the bottom of the unit. After the oven
is permanently placed, drill a hole through the counter top for a 5 mm self-tapping screw. The hole should be 20 mm
from the left side of the outer case cabinet and 180 mm back from the front edge of the cavity face plate.
9. Never stack two ovens.
Hole
180 mm
20 mm
SCA R2197 O/M P01-10 03.10.10, 6:14 PM 3