Smeg A41C-5 - Manual (Page 5)

Instructions for the installer
For operation on 380-415V3N
∼
: use an
H05RR-F-type five-core cable (5 x 2.5 mm 2 ).
For operation on 380-415V2N
∼
: use an
H05RR-F-type four-core cable (4 x 4 mm 2 ).
For operation on 220-240V
∼
: use an
H05RR-F-type three-core cable (3 x 6 mm 2 ).
The cable end to be connected to the
appliance must be provided with an ground
wire (yellow-green) at least 20 mm longer.
Complete wiring up to power supply with an appropriately rated five-core
plug (see data plate) or, in case of operation from a 220-240V
∼ power
supply, with a three-core plug. Make sure that plug and wall socket are
of the same type and are in conformity with regulations in force. Make
sure that the appliance is properly earthed. Before powering, check that
the power line is properly earthed. Avoid using adapters or shunters.
2.3
Instruction for wall fixing (only on some models)
1)
Fix the screw to the wall and hook the chain (B);
2)
Hook the chain to the hole positioned at the rear of the cooker by
the gas pipe (A);
3)
Once the chain is in position, push the cooker against the wall;
4) The height of the screw hole from floor level must not exceed 800
mm (C).
A B C
33