Swim'n Play oval 4ft pool - Manual (Page 23)

23
7" AND 9” TWO-PIECE WRAP AROUND COVER
AND PEDESTAL
Slide the inside cover (the cover which will be closest to the inside of the pool) into position
and align the hole in the cover with the cage nut attached to the top plate. Secure using the
1/4”-20 x 3/4” screw provided. Slide the outside cover onto the inside cover. Make sure the inside
cover is in the slot of the outside cover. Align the holes on the side of the bottom wrap with the
holes on the top of the vertical. Secure the cover using the #12 x 1/2” screws provided. The two
(2) edges of the covers should be parallel. Before tightening the screws, press the two covers
firmly together.
WRAP AROUND
PEDESTAL
Place the pedestal onto the
bottom of the vertical and align the
holes on the side of the wrap with
the holes on the bottom of the
vertical. Secure the pedestal using
the #12 x 1/2” screws provided.
INSIDE COVER
1/4”-20 X 3/4”
STAINLESS STEEL SCREW
#12X1/2” SCREW
1 ON EACH SIDE
#12X1/2” SCREW
1 ON EACH SIDE
If your pool vertical does not have holes, simply use
the cover or the pedestal as a template and drill through
the vertical using a 9/64" diameter drill bit, being careful
not to damage the pool wall.
9” WRAP
AROUND
COVER
7” WRAP
AROUND
COVER