Smeg SC166PZ - Manual (Page 27)

Instructions for the user
58
8.3 Removing door
With the door completely open, lift the levers A until they touch the
hinges B and take hold of the two sides of the door with both hands
close to the hinges. Raise the door to an angle of about 45° and remove
it. If the hinges have not locked, repeat the operation, raising the levers
and keeping the door slightly raised. To reassemble, fit the hinges B into
their grooves, then lower the door into place, ensuring that it remains
fitted into the grooves C.
8.4 Removing the door glass
The glass in the door should always be kept thoroughly clean. For
easier cleaning, the door glazing can be fully removed by proceeding as
described below. After blocking the door in position as described in point
"8.3 Removing door", remove the inner glass using leverage as shown
in figure 1, and release the 4 pins which fix the glass to the door.
If your oven also has the middle glass (figure 2) this can simply be lifted
out.
After cleaning, first fit the middle glass (if featured on your oven) and
then replace the inner glass, using the oven door supports as a fulcrum
as shown in figure 3 (see detail A in figure 3. Once the glass has been
fitted on the door, apply a little pressure against the 4 fixing pins.
If the door should close during these operations, simply relock one of
the hinges as described in point "8.3 Removing door". The panes of
glass can now be washed separately.