Source Technologies SECURE MICR PRINTER ST9612 - Manual (Page 2)

Source Technologies, LLC ST9612 Secure MICR Printer User’s Guide ii
Copyright
Copyright ©2009 by Source Technologies, LLC. All rights reserved.
No part of this document may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying, recording, or by any information
storage and retrieval system, without permission in writing from Source Technologies,
LLC.
Published in the United States of America by:
Source Technologies, LLC
2910 Whitehall Park Drive
Charlotte, NC 28273
Author: Source Technologies, LLC
Notice
This manual serves as a reference for a Source Technologies Secure MICR Printer.
This manual should be used as a reference for learning more about MICR technology
and developing MICR printing applications. This guide was produced to assist IS
Technicians and Engineers in the integration of Source Technologies’ programmed
printers with their custom MICR applications. The guide also contains information on
MICR related error messages that post to the operator panel.
To the best of our knowledge, the information in this publication is accurate: however,
neither Source Technologies, LLC, its dealers or affiliates assume any responsibility or
liability for the accuracy or completeness of, or consequences arising from, such
information. Changes, typos, and technical inaccuracies will be corrected in subsequent
publications. This publication is subject to change without notice. The information and
descriptions contained in this manual cannot be copied, disseminated, or distributed
without the express written consent of Source Technologies, LLC. This document is
intended for informational purposes only. Mention of trade names or commercial
products does not constitute endorsement or recommendation for use by Source
Technologies, LLC. Final determination of the suitability of any information or product for
use contemplated by any user, and the manner of that use is the sole responsibility of
the user. We recommend that anyone intending to rely on any recommendation of
materials or procedures mentioned in this publication should satisfy himself as to such
suitability, and that he can meet all applicable safety and health standards.
All trade names or products used in this manual are for identification purposes only and
may be trademarks or registered trademarks of their respective companies.
Document Number: 104048
Revision: A
Copyright