Sony DAV-DZ300 - Manual (Page 66)

66 GB
By adjusting the remote signal, you can control
your TV with the supplied remote.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the
code number may reset itself to the default (SONY)
setting. Reset the appropriate code number.
Controlling TVs with the
remote
Press and hold TV [ / 1 while entering your
TV’s manufacturer’s code (see the table)
using the number buttons. Then release TV
[ / 1 .
If you set successfully the manufacturer’s code,
the remote transmits the on/off signal of the TV.
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the one
that works with your TV.
TV
To control the TV
You can control the TV by using following
buttons.
* Only for the Sony TVs.
You can select the TV channels by using the
number buttons.
- is for selecting a channel number greater than
10. (For example, for channel 25, press -, then
2 and 5.)
• Depending on the TV, you may not be able to control
your TV or to use some of the buttons above.
Other Operations
Controlling the TV with the
Supplied Remote
Note
TV VOL +/–
TV/VIDEO
Number
buttons
TV CH –/+
TV ? / 1
TV
-
Manufacturer Code number
SONY 01
DAEWOO 02
GRUNDIG 16
HITACHI 02, 04
JVC 05
MITSUBISHI/MGA 02, 06
PANASONIC 12, 15
PHILIPS 13, 14
SAMSUNG 02, 07, 13
SANYO 03
SHARP 08
THOMSON 09
TOSHIBA 08, 10, 11
By pressing You can
TV [/1 Turn the TV on or off.
TV/VIDEO Switch the TV’s input source
between the TV and other input
sources.
TV VOL +/–
while pressing
the TV button Adjust the TV volume.
TV CH +/– while
pressing the TV
button Select the TV channel.
Number buttons
while pressing
the TV button* Select the TV channel.
Note