Servis-Rhino 2407TL - Manual (Page 89)

MAINTENANCE
2407TL 01/11 Maintenance Section 5-5
© 2011 Alamo Group Inc.
MAINTENANCE
Daily Maintenance
Regular maintenance of your loader and hydraulic system will insure maximum loader efficiency and long life.
1. Check fluid level of tractor hydraulic system before starting each day’s operation. If necessary, add
hydraulic oil as recommended in your tractor operator’s manual.
2. Daily, unless conditions justify more frequent greasing, lubricate all twelve grease fittings; one at each end
of lift boom arms and one at rod and base ends of each lift and bucket cylinder.
3. After every ten hours of operation, check all hardware and tighten where required.
4. Replace hoses immediately if they are damaged by a cut or scrape, extruded at the fittings or leaking.
Hydraulic oil leaks should be repaired promptly to avoid loss of oil and serious personal injury from
escaping oil.
Escaping hydraulic fluid under pressure can penetrate skin, causing serious personal injury.
• DO NOT use your hand to check for leaks. Use
a piece of wood or cardboard and wear eye
protection to search for leaks.
• Stop engine and relieve pressure before
connecting or disconnecting lines.
• Tighten all connections before starting engine
or pressurizing lines.
NOTE: If any fluid is injected into skin, obtain medical attention immediately or gangrene may result.
Adjusting Bucket Lever Indicator
With various tractor tire options or attachments it
may be necessary to adjust bucket level indicator
tube up or down on bucket cylinder tube. Tractor
must be on level surface with attachment flat on
surface. Loosen tightener band and adjust level
guide tube along bucket cylinder until end of guide
tube is flush with end of rod. Tighten band.