Shindaiwa H4 TRIMMER T344 - Manual (Page 19)

19
Adjusting Engine Idle
The engine must return to idle speed whenever the throttle lever is released.
Idle speed is adjustable, and must be set low enough to permit the engine
clutch to disengage the cutting attachment.
WARNING!
The cutting attachment must NEVER rotate at engine idle! If the
idle speed cannot be adjusted by the procedure described here, return the
unit to your Shindaiwa dealer for inspection.
Idle Speed Adjustment
1. Place the unit on the ground, then start the engine, and then allow it to idle
2-3 minutes until warm.
2. If the attachment rotates when the engine is at idle, reduce the idle speed
by turning the idle adjustment screw counter-clockwise.
3. If a tachometer is available, adjust idle. Check Specifications page for
correct idle speed
Loading Trimmer Line
1. Cut one piece of line to recommended length.
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of trimmer line into an eyelet, and push line
equal distance through trimmer head.
4. Hold trimmer head while turning knob clockwise to wind
line onto spool until about 5” (13 cm) of each line remains
exposed.
Trimmer head is now fully loaded and ready for operation.
.080 (2.0 mm) dia. - 20’ (6 m)
.095 (2.4 mm) dia. - 14’ (4 m)
.105 (2.7 mm) dia. - 10’ (3 m)
Maintenance (continued)
Idle
Ajust-
ment
Screw
1 2
3 4
Wear Indicators
Wear Indicators
Indicadores de desgaste
Indicadores de desgaste
Indicateurs d’usure
Indicateurs d’usure
NOTE:
Trimmer head is pre-wound with .095" (2.4mm) Crossfire™
trimmer line.
IMPORTANT!
When the wear indicators located at the bottom of the Speed-Feed ® head are worn smooth, or if holes appear, replacement
of the cover or the entire Speed-Feed ® head is required.