Sunrise Medical Kid Kart Mighty Lite - Manual (Page 19)

V I I . O p e r a t i n g I n s t r u c t i o n s
100336 Rev. D
20
A
A
11
12
13
G. SEAT DEPTH ADJUSTMENT
1. Determine the proper seat depth.
2. To change seat depth, undo the Velcro® that
attaches the back panel to the seat panel of the
sling. (Fig. 9)
3. Relieve fabric tension by partially folding the
chair.
4. Depress spring button on the side of the seat rail
(Fig. 10A) and move seat tube to the desired
depth until spring button relocates. (Fig. 10B)
5. Repeat operation on other side of seat (Fig. 10C).
6. Reattach the seat panel to the back panel of the
sling (Fig. 9) for proper adjustment.
H. SEAT AND BACK ANGLE ADJUSTMENT
To adjust the seat angle:
1. Locate the seat angle adjustment bolt along the
seat rail (Fig. 11A).
2. Loosen and remove fasteners from both sides of
the seat and relocate as required in the top or
bottom hole (Fig. 12). See Set-up matrix for
proper location.
3. Secure the nuts tightly.
CAUTION– The modification of the seat angle will affect the
back angle. Consult matrix to validate the adjust-
ment of the back in conformity of the seat-to-
back angle. Refer to the “Back Angle Adjustment”
section if necessary.
To adjust the back angle:
1. To adjust the back angle relative to the seat,
consult the Set-up Matrix (Page 23).
2. To relocate the back post along the seat rail,
loosen and remove fasteners from both sides of
the seat (Fig. 12) and align the back posts along
the seat rail in the required location.
3. Put fasteners back in place and secure the nuts
tightly.
4. When the adjustment of the top of the back post
is necessary according to the Set-up Matrix,
remove fasteners from both sides of the frame
(Fig. 13). Align the cross-brace along the back
post in the required location. Insert fasteners on
both sides. Secure the nuts tightly.
A
B
C
9
10