Sony PCV-RXP-RZP - Manual (Page 48)

VAIO Digital Studio System Reference Manual 34
8 If necessary, remove any add-on cards to gain access to the battery.
You may also need to disconnect some cables.
9
Use a small flathead screwdriver or your finger to push in (not down)
against the small tab at one end of the battery holder to release the
battery.
Installing a lithium battery (PCV-RX series model)
10 Gently lift out the battery and dispose of it properly.
11
Insert the new battery into the battery holder, with the plus (+) side
up, and press down until the battery is secure.
12
Replace any add-on cards that were removed.
13 Reconnect any cables that were disconnected.
14 Replace the side panel (see “Replacing the Side Panel” on page 26).
15 Reconnect the power cord and turn on the computer.
!
Touch any exposed metal part of chassis to discharge static electricity in
your body before handling an add-on card or other sensitive electronic
component.
✍
The Sony CR2032 battery is recommended. Using a type of battery other than a
CR2032 may present a risk of fire or explosion.
Push the tab in (not down) to
release the battery