Sony CDX-M7810 - Manual (Page 11)

11
CDX-M7815X/M7810
2-586-657-11 (1)
H:\Data Disk\2586657111\258665711CDXF7815XU\01US02CD-U.fm masterpage:Right H:\Data Disk\2586657111\258665711CDXF7815XU\01US02CD-U.fm masterpage:Right
Setup y Display y Receive Mode
y Sound y Edit y List
3 Rotate the SEEK control dial until
desired setting item appears, then
press
(ENTER) .
The digital indication moves to the right
(setting selection) side.
4 Rotate the SEEK control dial to select
the setting, then press
(ENTER) .
The setting is complete.
5 Press (MENU) .
The display returns to normal play/reception
mode.
Note
Displayed items will differ, depending on the source
and setting.
With the card remote commander
In steps 2 and 3: press
M or m instead of the SEEK
control dial; in step 4, press < or , instead of the
SEEK control dial.
The following items can be set (follow the page
reference for details):
“
z ” indicates the default settings.
Setup
Display
Receive Mode
Sound
Clock Adjust (page 4)
Beep
To set “on” (
z
) or “off.”
AUX-A * 1 (AUX Audio)
To turn the AUX source display “on” ( z ) or “off”
(page 13).
Clock (Clock Information)
To display the clock and the display items/image
at the same time.
– “on”: to display at the same time.
– “off” (
z ): to not display at the same time.
A.IMG (Auto Image)
Auto Image mode automatically steps (every 10
seconds) through the display images.
– “off” (
z
): to not change the image
automatically.
– “SA”: to step repeatedly through the display
images of Spectrum analyzer.
– “Movie”: to step repeatedly through the
display images of Movie mode.
– “All”: to step repeatedly through the display
images in all display modes.
Info (Display Information)
To display the items (depending on the source,
etc.) at the middle of the display while a image
is displayed.
– “on” (
z
): to display the items.
– “off”: to not display any items.
Dimmer
To change the brightness of the display.
– “Auto” (
z
): to dim the display automatically
when you turn lights on.
– “on”: to dim the display.
– “off”: to deactivate the dimmer.
Demo * 1 (Demonstration)
To set “on” ( z ) or “off” (page 4).
A.Scroll (Auto Scroll)
To scroll long displayed item automatically
when the disc/group/track is changed.
– “on”: to scroll.
– “off” (
z ): to not scroll.
Local (Local seek mode)
– “on”: to only tune into stations with stronger
signals.
– “off” (
z
): to tune normal reception.
Mono (Monaural mode)
To improve poor FM reception, select monaural
reception mode.
– “on”: to hear stereo broadcasts in monaural.
– “off” (
z
): to hear stereo broadcast in stereo.
IF
– “Auto” ( z ): to narrow automatically the
reception frequency to eliminate noise.
– “Wide”* 2 : to always hear FM stereo
broadcasts in stereo and with full the
frequency signal reception.
EQ7 Tune (page 9)
HPF (High Pass Filter)
To select the front/rear speaker cut-off
frequency: “off” (
z
), “78Hz” or “125Hz.”
LPF (Low Pass Filter)
To select the subwoofer cut-off frequency: “off”
(
z ), “125Hz” or “78Hz.”
Loudness
To enhance bass and treble at lower volume.
– “on”: to reinforce bass and treble.
– “off” (
z
): to not reinforce bass and treble.
AUX Level
To adjust the volume level for each connected
auxiliary equipment (page 13). This setting
negates the need to adjust the volume level
between sources.
continue to next page t