Kalorik USK JK 28345 - Manual (Page 5)

Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
5 USK JK 28345 - 091125
Assembly page 5/28
Fax +32 2 359 95 50
CAUTION : read, understand and follow all the important
safeguards and operating instructions in this Use and Care guide
before using this product.
BEFORE THE FIRST OPERATION
For a perfect taste, operate the jug kettle with fresh water in order to
clean any residue left from the manufacturing process. When the
appliance has cooled down, repeat the process 3 times with fresh
water, before rinsing.
OPERATION
•
Always remove the jug from the power base before filling it or
before any operation.
•
Open the lid by pressing its release button and fill the tank with
fresh water, paying attention not to fill under the minimum mark
and above the maximum mark on the water level indicator. Too
little water may result in the kettle switching off before the water
has reached temperature.
•
Close the lid by pressing it down until it you hear a click. Make
sure it closes correctly.
•
Put the jug onto the power base, plug into the wall socket. The
temperature “212” will flash for approx. 10 seconds. Your kettle is
operational.
•
Your kettle can be used both for boiling water or bring it to your
desired temperature. This is particularly interesting for the
preparation of hot beverages, most especially tea, as the ideal
brewing temperature can be different from one sort to the other.
•
Press the on/off button on the control panel to turn the kettle on.
The water boiling temperature “212” (°F) will flash for a few
seconds, during which the temperature can be changed to your
liking. For this, press “+” or “-“ to set the kettle to the desired
temperature. When the screen stops blinking, the temperature is
set and the kettle will start warming the water. The red “Power” LED
is lit.
•
When the kettle reaches the desired temperature, the kettle will
turn off and will produce 5 short beeps. The water temperature is